How/were should i put the 4 gauge wire to get it into the hood area for an aftermarket amp jetta 2000glx? - how to put an aluminium floor in aboat
I am ready to install my amp, but I can not make the cable 4 of the gauge field bell, I need a new hole? any help would be really grateful, thank you
Sunday, January 31, 2010
How To Put An Aluminium Floor In Aboat How/were Should I Put The 4 Gauge Wire To Get It Into The Hood Area For An Aftermarket Amp Jetta 2000glx?
2 comments:
There are some things you can do.
If the tank is the carpet in the trunk of a rubber stopper on the bottom of the pan. Grasp the plug, carefully cut a hole in the center large enough for the cable. where the power cord into the plastic cover that is provided with the kit and use cable tie the cable securely to the factory found in the car, run the wire to the engine and online backup of the battery. ..... be sure to stay out exaust from areas of high heat, intake manifold, engine block, etc.
Option 2
Put the cable under the carpet to the carpet under the table is ready. Find a rubber plug in the wall of fire on the driver's side and carefully cut a hole big enough for cable. then run the wire to the fuse, and then the battery. away from areas with a high temperature.
If you cut the big hole in the plug, then you can go to parts store and use rubber apoxy supplement, but make sure the hole is cut sealed so that water does not go in the car whenpouring rain. Allso if you do not find the plug from the wall of fire to find a place in the wall of the fire drill. Parts or hardware store will rubber stopper. Verify before you buy plugs used to make holes in the correct driver for 4gauge drills have a pilot hole then drill the hole the right size and make sure that you drill to ensure that all the wiring and vehicle before.
Allso think of it, run the remote wire on the hot wire does not go threw it twice. Remote control cable (blue) connects to the car radio / CD player.
If you use the tools, drill a hole. Before you come to cable or beam current son in the car at the wrong domain. The son in the car, which by a rubber sleeve or plug. Just pull the rubber part and / or put a hole, and then run the wire. While under the hood, you look around on the driver's side. The cable should run on this page under the dash driver's side.
Post a Comment